![](/images/new-backgrounds/1041925/4192563x1.webp)
ST-45 PUMP — INITIAL START-UP PROCEDURE
Starting
CAUTION :
DO NOT attempt to operate this concrete pump until the Safety, General Information and Inspection sections have been read and understood.
EMERGENCY STOP SWITCH
1.Locate the Emergency Stop Switch (Figure 19) on the Hydraulic Pump Control Box. Use this switch in the event of a emergency.
IGNITION SWITCH
3.To start the engine, insert the key (Figure 20) into the ignition switch and turn the key to the ON position.
Figure 20. Ignition Switch
4.Observe that the Batter,Air Filter and Oil Pressure status indicator lights are “ON” (Figure 21).
BATTERY OIL AIR FILTER
PRESSURE
Figure 19. Emergency Stop Switch
2.Turn the Emergency Stop switch
If the Emergency Stop switch is in the
NOTE “CLOSED” position (stop), engine will not start. To start the engine, make sure the Emergency Stop switch is in the “OPEN” position (fully extended).
NOTE
Place all switches on the Hydraulic
Control Box in the ”OFF” (up position).
Figure 21. Status Indicator Lights
A.Turn the key to the “START“ position and listen for the engine to start.
B.In warm weather let engine
C.The Air Filter,Oil Pressure and Battery indicator lights (Figure 21) should all be “OFF”.
The battery indicator light may remain
NOTE on if the engine is idling, or on some models of the
CAUTION :
If any of the status indicator lights referenced in the ignition section (step 4) remain “ON”, turn off the engine and correct the problem. DO NOT continue to run the equipment.
PAGE 32 — MAYCO