Murphy CE-05171N NO-FLOW Input # 1 Setup Cycle Time SEC Total Cycles, Cycle Timer SEC More Menus

6.3.14 Lube No Flow Set Up
		C	TM
	LUBE NO-FLOW SETUP
	NO-FLOW INPUT # 1			▼
	NO-FLOW INPUT # 2
	NO-FLOW INPUT # 3
	NO-FLOW INPUT # 4
	NO-FLOW INPUT # 5
	___________________________________
	DI_1 NF			▼
	___________________________________
	▼▲	ENTER-SUBMENU
	▼ ▼	MORE MENUS
		Lube No-Flow Setup Screen
		C	TM
	NO-FLOW INPUT # 1 SETUP
	CYCLE TIME (SEC)			▼
	TOTAL CYCLES (X100)
	___________________________________
			00010	▼
	___________________________________
	▼▲	ENTER-EDIT
		ESC-EXIT THIS MENU
		No-Flow # 1 Setup Screen
6.3.15 Lube No Flow Status
		C	TM
	LUBE NO-FLOW STATUS
	CYCLE TIME-INPUT # 1			▼
	CYCLE TIME-INPUT # 2
	CYCLE TIME-INPUT # 3
	CYCLE TIME-INPUT # 4
	CYCLE TIME-INPUT # 5
	___________________________________
	PREV	0 CURR 0		▼
	___________________________________
	▼▲	CYCLE TIMER (SEC)
	▼ ▼	MORE MENUS

Lube No-Flow Status Screen

6.3.16 Super User Menu

C	TM
SUPER USER MENU
COM FAIL DISABLE	▼
SETUP T/O DISABLE
CONFIG FAIL DISABLE
RESET FAULT HISTORY

RESET EVENT HISTORY

___________________________________

NO ▼

___________________________________

▼▲	ENTER-EDIT
▼ ▼	MORE MENUS
	Super User Menu Screen

User can view and edit Lube No Flow set up. There are two levels to this menu as there are two possible adjustments per No-Flow input. The user will select an input from the first menu and press Setup/Enter. This will display the submenu for the selected digital input if it is used for No-Flow monitoring. Otherwise, the text label on the left side of the edit box will dis- play “NOT IN USE”, and pressing Enter will have no effect.

At the submenu level, the user may adjust the expected tran- sition frequency and the total cycles count (which relates to the wear rate of the sensor).

The user may view information about the No-Flow inputs. If a digital input is designated for use as a No-Flow input, it will display how much time elapsed before the last transition, and how much time has elapsed since that transition. If the input is not designated as a No-Flow input, there will be zeros dis- played. Both values have a maximum value of 999.

The Super User menu will only be visible if the Super User password has been entered.

The first three selections (a – c) allow the user to temporarily override the default behavior of the display. It may be helpful to turn off a fault annunciation screen that prevents the view- ing of information on operating status screens.

a)Com Fail Disable

b)Set up T/O Disable

c)Config Fail disable

Note that the reset history commands do not permanently switch to Yes when entered, but instead toggle back to NO after sending the command to the controller.

CE-05171N page 32 of 44