CLI Commands, Continued…
Show or Set SNMP Configuration
Command Name | Snmp |
|
Description | Show or set SNMP configuration. If no parameters are specified, this command will | |
| show the SNMP configuration (same as | |
Syntax | snmp | |
Parameters |
| |
| Show configuration. |
|
|
| |
| Set the Authorized Community Name for SNMP Get requests. | |
|
| |
| Set the Authorized Community Name for SNMP Set requests. | |
|
|
|
| Set the Authorized Community Name for SNMP Traps. | |
Examples |
| |
| IP Address - Trap Stn.#1 | : Value Not Configured |
| IP Address - Trap Stn.#2 | : Value Not Configured |
| IP Address - Trap Stn.#3 | : Value Not Configured |
| IP Address - Trap Stn.#4 | : Value Not Configured |
| IP Address - Trap Stn.#5 | : Value Not Configured |
| : users | |
| ||
| Trap Community Name | : public |
| Changes have been made that have not been saved. | |
| … |
|
NOTES | Community names may only contain alphanumeric, space, | |
| and may not begin with a number, space, or underscore. A name with embedded space | |
| characters must be enclosed in quotes. The maximum length is 15 characters. | |
Show or Clear the Last System Error |
| |
Command Name | Syserr |
|
Description | Show or clear the last system error |
|
| If clear is not supplied, then the last system error is displayed. | |
Syntax | syserr [clear] |
|
Parameters | Clear |
|
| Clear the last system error. |
|
Example |
| |
| Last System Error: None. |
|
|
| |
| Last System Error: Cleared. | |
Notes |
|
|
(Revised | Page 135 of 156 |