DIO 6533 User Manual I-2
©
National Instruments Corporation
interrupt channel selection, 2-6 to 2-9
Plug and Play mode, 2-5
switchless data acquisition, 2-5
PCI, PXI, and DAQCard devices, 2-4
control signal summary, 4-7
CPULL signal
description (table), 4-5
pull-up and pull-down connections, 4-13
to 4-14
customer communication, xiv, C-1 to C-2
D
DAQ-DIO chip, 1-2
DAQCard-6533
block diagram, 3-4
configuration, 2-4
installation, 2-3 to 2-4
overview, 1-1
data signal connections, 4-9 to 4-13
example (figure), 4-11
strobed I/O, 4-12 to 4-13
unstrobed I/O, 4-10 to 4-12
digital I/O specifications, A-1 to A-3
DIO 6533 devices
optional equipment, 1-7
overview, 1-1 to 1-2
requirements for getting started, 1-3 to 1-4
software programming choices, 1-4 to 1-6
National Instruments application
software, 1-4 to 1-5
NI-DAQ driver software, 1-5 to 1-6
register-level programming, 1-6
unpacking, 1-8
using PXI with CompactPCI, 1-2 to 1-3
DIOA<0..7> signal
description (table), 4-4
unstrobed I/O, 4-10 to 4-11
DIOB<0..7> signal
description (table), 4-4
unstrobed I/O, 4-10 to 4-11
DIOC<0..7> signal (table), 4-4
DIOD<0..7> signal (table), 4-4
DMA channel selection
PC AT 16-bit DMA channel assignment
map (table), 2-9
software configured, 2-6
documentation
conventions used in manual, xii
National Instruments documentation,
xii-xiii
organization of manual, xi-xii
related documentation, xiii
DPULL signal
description (table), 4-5
pull-up and pull-down connections, 4-13
to 4-14
drive current characteristic, 4-6
E
e-mail support, C-2
electronic support services, C-1 to C-2
environment specifications, A-9
environmental noise, minimizing, 4-14 to 4-15
equipment, optional, 1-7
F
fax and telephone support, C-2
Fax-on-Demand support, C-2
field wiring and termination, 4-14 to 4-16
FTP support, C-1
full handshaking transfer. See handshaking
transfer.
G
GND signal (table), 4-5
ground reference characteristic, 4-6
groups of ports, 3-5