National Instruments none

Chapter 5 Getting Started with Measurement Studio

5. To complete the DAQ configuration, select the N Samples Acquisition

Mode in the Timing Settings section. For more information on

timing, refer to Timing in the NI-DAQmx Help.

6. Next, click the Run button in the toolbar near the top of the Edit DAQ

Task dialog box. The test runs automatically. You can run the test in the

DAQ Assistant to test the task and make sure you connected the signal

properly. If necessary, you can modify the settings before any code is

generated.

7. Click the Finish button in the Edit DAQ Task dialog box to complete

the configuration of your DAQ task and to launch the Configure DAQ

Component UI wizard.