Removing a CO/PBX Line from Hold
-depress fluttering or intermittent winking Ic6
-lift handset
4.Hold Recall
An audible recall signal, a fluttering COIPBX LED and a display are provided to idle keysets that have
longer than the programmable time.
-display shows IT]
X corresponds to CO line recalling
-depress fluttering m
-lift handset
Note: Display will indicate the held lines of the station sequentially, for 0.8 set each.
5.Abandoning a Call Abandoning a Call
-at the end of the call, depress the Recall Key
-CO call is released, but the line is retained and new dial tone is heard.
-dial next call
Abandoning Using Handset
depress B for desired station
(if a previous CO/PBX call was in progress, the call is placed on hold automatically)
receive tone burst
display shows called station number m]
after response, use handset to talk
To a Busy Station
-same as above (first 3 steps)
-receive call waiting tone
-wait until called station answers or restore handset.
Note: Calling party will receive busy tone when called . station is in Do Not Disturb mode or receiving an
ICM call. The called station’s display wit! not show the calling station’s number.
2.Answering Idle Station
-receive tone burst
- | display | shows calling station’s | number | 1x1 | , |
| ICM Flashes |
|
|
| |
- | converse | handset |
|
| |
Busy Station on COjPBX Line
-receive half volume tone burst from speaker
- restore handset |
-
display shows calling station’s number
- CO/PBX line is released |
Abandoning when in Monitor Mode
-depress q,s
-$$ LED goes off and CO/PBX line is released •I
410.2Intercom (Internal) Calls
1.Originating
To an Idle Station
-lift handset or depress $ cl
ICM Flashes
- depress m and converse immediately with call- ing party,
or
-continue existing CO conversation
Note: After call is abandoned and busy station becomes idle, the display will show the number of the last ICM party that called for 3 seconds.
Page
