E-16
Remote Control Notes• Use the remote control within a distance of about 7m (23feet)
and at an angle of 30˚ above, below, to the left and to the right of
the remote control sensor located at the front of the main unit.
• The remote control system may not function when direct
sunlight or strong illumination strikes the remote control sensor
of the main unit, or when there is an obstacle in the path.
• When remote control buttons are pressed and held, main unit
function keys may not operate.
• Do not subject to strong shock.
• Do not allow water or other liquid to splash on the remote
control. If the remote control gets wet, wipe it dry immediately.
• Avoid exposure to heat and steam.
• Remove the batteries from the remote control when the remote
control is not going to be used for a long period.
You cannot operate the projector using the remote con-
trol if:
• the remote ID is not set to [00].
• the remote ID is not the same as the projector ID.
See page E-43 for setting remote ID and page E-38 for setting
projector ID.
Attaching the supplied ferrite clamp
The ferrite clamp is provided with this projector in order to reduce
electromagnetic interference that may cause interference to radio
communication.
1. Push the catch and open the ferrite clamp.
2. Draw the remote cable through the hole and wind the remote
cable around the ferrite clamp two times, then close the ferrite
clamp. Place the ferrite clamp as closely to the end of the cable
that plugs into the projector as possible.