Connecting Your PC or Macintosh Computer
IBM VGA or Compatibles (Notebook type) or Macintosh (Notebook type)
Audio cable (not supplied)
IBM VGA or Compatibles (Desktop type)
RGB signal cable (supplied)
To mini
PC | CONTROL |
|
| S |
|
PO | TATUS |
|
| WER |
|
| ON/ |
|
| STAN |
|
| D BY |
|
|
| SO |
|
| URCE |
|
| AU |
A |
| TO A |
UDIO |
| DJUST |
| VIDEO | MEN |
| U | |
| S- | SE |
| VIDEO | LECT |
|
| R |
| RGB | CAN |
AUDIO |
|
|
AUDIO | RGB |
|
VIDEO | INPUT | |
| VIDEO | |
| S- |
|
Macintosh (Desktop type)
For older Macintosh, use a commercially available pin adapter to connect to your Mac's video port.
NOTE: The new Macintosh computer such as G3 will have the 15 pin HD connector. The LT75Z's "Plug and Play" data will be downloaded to the Macintosh. Therefore, a Mac adapter will not be necessary.
Pin adapter for Macintosh (not supplied)
Connecting your PC to your LT75Z (SVGA) projector will enable you to project your computer’s screen image for an impressive presentation.
To connect to a PC or Macintosh computer, simply:
1.Turn off the power to your projector and computer.
2.Use the supplied signal cable to connect your PC or Macintosh computer to the projector.
3.Turn on the projector and the computer.
4.If the projector goes blank after a period of inactivity, it may be caused by a screen saver installed on the computer you’ve connected to the projector.
