3. OPERATION

Connecting the Power Cable and Turn on the Projector

Before you turn on your projector, ensure that the computer or video source is turned on and that your lens cap is removed.

1 Connect the supplied power cable to the projector.

 

 

 

SELECT

N

 

 

 

 

L

 

 

 

 

E

 

 

 

 

C

 

 

 

 

CA

 

 

 

ENTER

 

 

ST

 

 

 

 

JU

 

 

 

 

AD

 

 

 

 

TO

 

 

 

 

AU

 

 

 

 

CE

 

 

 

 

UR

 

 

 

 

SO

 

 

 

/

BY

 

RGB

 

ON

ND

 

 

 

STA

 

 

 

 

S-V

IDEO

 

IN

R

 

 

AC

 

 

 

WE

VIDEO

 

 

 

 

 

 

 

 

AUDIO

 

 

 

 

OL

 

 

 

 

NTR

 

 

 

 

CO

 

 

 

 

PC

 

 

 

Plug the supplied power cable in the wall outlet. The pro- jector will go into its standby mode and the power indica- tor will glow orange.

2 Turn on and off the Projector.

Power button

RGB VIDEO S-VIDEO POWER

AUTO ADJ.

MAGNIFY VOLUME

To turn off the projector:

First press the “POWER” button on the projector cabinet or the remote control for a minimum of two seconds. The power indi- cator will glow orange. After the projector turns off, the cooling fans keep operating for 90 seconds.

NOTE: Do not disconnect the power cable during this time. Then, un- plug the power cable. The power indicator will go out.

Status of indicator light: turn on

Normal mode:

stand by

STATUS

ON/STAND BY

POWER

 

 

steady orange light

 

 

 

STATUS

STATUS

 

POWER

POWER

 

flashing green light

steady green light

Eco mode:

for one minute

 

 

 

stand by

 

 

STATUS

ON/STAND BY

POWER

 

 

steady orange light

 

 

 

STATUS

STATUS

 

POWER

POWER

PICTURE FREEZE MUTE ASPECT

MENUHELP

ENTERCANCEL

RD-372E

POWER ON/STAND BY button

 

STATUS

 

 

POWER

 

 

ON/

 

 

STAND

BY

 

 

 

 

SOUR

CE

 

 

Indicator

 

 

flashing green light

steady green light

for one minute

(Eco mode)

(Normal mode)

 

Status of indicator light: turn off

 

ON

 

POWER

ON/STAND BY

 

 

press a minimum of

steady green light

two seconds

 

cooling down

stand by

To turn on the projector:

Only after you press the “POWER” button on the projec- tor cabinet or the remote control will the power indicator turn to green and the projector become ready to use.

NOTE: To turn the projector on by plugging in the power cable, use the menu and enable the “Auto Start” feature. (See page E- 32.)

NOTE: Immediately after turning on the projector, screen flicker may occur. This is not a fault. Wait 3 to 5 minutes until the lamp lighting is stabilized.

POWER

POWER

change to flashing

steady orange light

green light

 

3 Adjust a Projected Image.

Select the Computer or Video Source

SOURCE

 

AUTO

ADJUST

 

E N

T E R

MENU

SELECT

CANCE L

E-21

Page 21
Image 21
NEC LT75Z user manual Operation, Connecting the Power Cable and Turn on the Projector