CHAPTER 7 INTERRUPT AND TEST FUNCTIONS
204 User’s Manual U10676EJ3V0UM
7.8 Effective Usage of Interrupts
Use the interrupt function effectively as follows.
(1) Use different register banks for the normal routine and interrupt routine.
The normal routine uses register banks 2 and 3 with RBE = 1 and RBS = 2. For the interrupt service routine
for one nested interrupt, use register bank 0 with RBE = 0, so that you do not have to save or restore the
registers. When two or more interrupts are nested, set RBE to 1, save the register bank by using the PUSH
BR instruction, and set RBS to 1 to select register bank 1.
(2) Use the software interrupt for debugging.
Even if an interrupt request flag is set by an instruction, the same operation as when an interrupt occurs is
performed. For debugging of an irregular interrupt or debugging when two or more interrupts occur at the same
time, the efficiency can be increased by using an instruction to set the interrupt flag.
7.9 Application of Interrupt
To use the interrupt function, first set as follows using the main program.
(a) Set the interrupt enable flag of the interrupt used (by using the EI IE××× instruction).
(b) To use INT0, select the active edge (set IM0).
(c) To use nesting (of an interrupt with a higher priority), set IPS (IME can be set at the same time).
(d) Set the interrupt master enable flag (by using the EI instruction).
In the interrupt service program, MBE and RBE are set by the vector table. However, when the interrupt specified
as having a higher priority is serviced, the register bank must be saved and set.
To return from the interrupt service routine, use the RETI instruction.