3. SETUP

Connecting the Power Cable and Turning on the Projector

Before you turn on your projector, ensure that the computer or video source is turned on and that your lens cap is removed.

1.Connect the supplied power cable to the projector. Plug the supplied power cable into the AC outlet.

To the wall outlet

Open the cover of the

power cable to plug fully into the AC IN on the projector.

2. Turn On The Projector

 

[POWER] switch

The main power switch is on the front panel of the projector.

 

 

By pushing up this switch, the projector will go into its standby mode and the POWER

 

indicator will glow orange. Only after you press the 'POWER ON' button on the remote

 

control or projector cabinet will the POWER indicator turn to green and the projector

 

will fully turn on.

 

 

ON

POWER

 

 

 

OFF POWER

ON/OFF

STATUS

3. Turn Off The Projector

First press the POWER OFF button on the remote control or the projector cabinet for a minimum of two seconds. Allow the fan to cool the projector for three minutes.

This will extend the life of the lamp. After the cooling fan stops working, the POWER indicator will change to a steady orange glow and the projector will be in the stand-by mode. Then turn off the main power switch on the front panel. The POWER indicator will go out. If you desire to move the projector then unplug the power cable.

ON

 

POWER

 

 

 

 

ON/OFF

OFF

POWER

STATUS

 

[POWER] button

[POWER] indicator

NOTE: Immediately after turning on the projector, screen flicker may occur. This is not a fault. Wait 3 to 5 minutes until the lamp lighting is stabilized.

 

POWER

 

INPUT

 

 

ON

OFF

1 ABC

2 DEF

3 GHI

CAUTION: Do not turn off the main power while the cooling fan is working.

 

 

 

 

 

 

TEST

 

4 JKL

5 MNO

6 PQR

ON

IMAGE/ PROJECTOR

7 STU

8 VWX

9 YZ/

 

 

 

 

 

OFF

PICTURE WHITE BAL.

 

0

 

 

 

 

 

 

ADJUST

E – 11