NEC SX10000 Using the RGB DIGITAL connectors, Link Mode, Connection for Double Stacking in Link Mode, Connecting a PC with the RGB digital connector

Using the RGB DIGITAL connectors

The Link mode function allows you to adjust or set multiple projectors using the RGB DIGITAL and OPTION connectors. The DVI DIGITAL input accepts up to the SXGA (1280 x 1024 @75Hz) signal in Link mode.

NOTE: The Auto Adjust feature does not work for DVI digital signal. When DVI signal is selected and the image position is not corrected, adjust the horizontal and vertical position using the Position screen. See page E-33 for more details.

Connection for Double Stacking in Link Mode

Connect source equipment to the master projector.	Master
	projector
	DVI-D cable (supplied)
	Supplied ferrite clamp core
	Slave
	projector

RGB DIGITAL		RGB DIGITAL		NOTE:
OUTPUT	INPUT9	OUTPUT	INPUT9	NOTE:
				*	Use the supplied DVI-D cables for stacking.
OPTION		OPTION		*	The end with the ferrite core should go to the RGB DIGITAL OUT-
IN		IN			PUT of the projector.
					PUT of the projector.
OUT		OUT		*	Specify the DVI-D type when you buy DVI cable.
OUT		OUT			When you use commercially available DVI cables, they must be 5

					m (16.4 feet) or less in length.
Master projector		Slave projector

Bi-directional RS-232C cable (not supplied)

It is recommended that you use a commercially available distribution amplifier if you use signals other than VGA (640X480@60Hz) to SXGA (1280X1024@75Hz) in Link mode.

Link Mode

You can daisy-chain up to 16 projectors and operate them separately with the same remote control in wired operation.

Master

Slave1

Slave16

Connecting a PC with the RGB digital connector

Connect the RGB DIGITAL IN connector of the projector to a digital connector of your computer.

RGB digital connector

RGB DIGITAL IN connector

DVI-D cable

Information for Reducing Radiation of Electromagnetic Waves

To reduce unnecessary radiation of electromagnetic waves, use the supplied ferrite clamp core,

Installation Instructions

1.Open and attach the ferrite clamp core to the supplied DVI-D cable as close as possible to the end that goes to the projector.

*Push the catch to open the ferrite clamp core.

3.Fix the supplied band to the cable as a stopper.

*Pull the end of the band to tighten it. Cut off the surplus of the band.

2. Close the ferrite clamp core tightly.

Band

NOTE: Be sure to use the ferrite clamp core at the end of the DVI-D cable.

E – 24