NEC SX10000 7. Optional Accessories, REMOTE 3 (XLR) Pin Assignments and Signals

7. Optional Accessories

Lens	TL-08SF (Short Focal Lens 0.84) : 10kg
	TL-1ZH (Zoom Lens 1.5 - 2.5:1) : 5.5kg
	TL-2Z (Zoom Lens 2.5 - 4.0:1) : 4.5kg
	TL-4Z (Zoom Lens 4.0 - 7.0:1) : 4.5kg
Interface Board	XT SDI BOARD
	SX HDSDI Board
Ceiling Mount Kit	XL CMKIT
Switcher	ISS-6020 Video/RGB Switcher

A Serial Digital Interface (SDI) board is optionally available.

XT SDI BOARD

This board accepts the input of non-compressed signal sources such as commercial type digital VTR (e.g., D1/D5-VCR) compatible with digital serial component signals (of the SMPTE 259M-C standard) and provides a high quality image without quantization noise. Note that the BNC cable used with the SDI connector should be Belden 8281 cable, or 3C-2V equivalent cable or better.

Packaged items: SDI board (1), shield case (1), connector cable (1), and installation manual (1)

SX HDSDI Board

This board accepts the input of non-compressed signal sources such as commercial type digital VCR (D5-VCR) compatible with digital serial component signals (of the SMPTE 292M standard) and provides a high quality image without quantization noise. This board accepts the following image formats.

System	Number of samples	Number of active	Frame rate (Hz)	Scanning format	Sampling	Total number of	Total number of
	of active 1 line	lines in 1 frame			frequency (MHz)	samples in 1 line (dot)	lines in 1 frame
1920x1035/60/2:1	1920	1035	30	2:1Interlace	74.25	2200	1125
1920x1080/60/2:1	1920	1080	30	2:1Interlace	74.25	2200	1125
1280x720/60/1:1	1280	720	60	Progressive	74.25	1650	750
1920x1080/24(sF)	1920	1080	24	Progressive	74.25	2750	1125

Note that the BNC cable used with the HDSDI connector should be 5C-FB equivalent cable or better.

Packaged items: HDSDI board (1), shield case (1), connector cable (2), flat cable (1), set screw for shield case (2) and installation manual (1)

REMOTE 3 (XLR) Pin Assignments and Signals

REMOTE3

OUTIN

12

2	1	3	IN		OUT
3
		Pin No.	Signal	Pin No.	Signal
		1	Ground	1	Ground
		2	+3.3V	2	No connection
		3	DATA IN	3	DATA OUT

NOTE: The wireless remote control can operate even if the plug of the remote cable is inserted into REMOTE 3 (XLR) connectors. For the wireless remote control not to operate, insert the plug of the remote cable into the REMOTE2 IN jack.

E – 44