Color Matrix
First, select an appropriate color matrix for your input signal, either HDTV or SDTV. Then select an appropriate matrix type from
NOTE: The Color Matrix feature is available for component video signal only.
Y/C Delay (not available for RGB)
Adjusts Y/C delay level.
Telecine
Use 3:2 pull down correction to eliminate jitter and artifacts in video.
Auto ............. | For film source such as a DVD player |
Off ................ | For signals other than film sources |
Motion Select |
|
Sets the interpolation method. Selects Still or Adaptive. Still is used for non moving images such as a document camera. Select Adapter for all motion video.
Motion Level
Adjusts level of motion detection when Adaptive is selected.
YTR Adjustmen (not available for RGB)
Adjusts luminance transient time.
CTR Adjustment (not available for RGB)
Adjusts chroma transient time.
Clamp Timing
According to the signal, this function sets the detection position (i.e., clamp position) of the black level reproduction of the analog input signal. Normally this is not used. (1080P is set as the default)
Auto ............. | This is the normal setting. |
This is set when projecting HDTV video. | |
Front Porch .. | This is set when the picture quality does not improve even |
| though Auto or |
Adjust .......... | This permits the video clamp position for each signal to be |
| set. Use "Adjust" when a clamp timing error occurs at the time |
| of special analog signal reception such as 1080P. Note that |
| "Adjust" is not valid for doubler signals such as NTSC and |
| PAL. |
To delete the "Clamp Timing" setting screen, select the SELECT ▼ button and press the ENTER button, or press the remote control CANCEL button.
Sync Protection
When a VCR, DVD, or some other equipment that supports Copyguard (a copy prevention system) is played back, the screen may be displayed in a curved manner. Adjustments are made in such circumstances. Use the SELECT or button to adjust the VD level.
VD Delay
This feature is used to correct vertical jitter of
NOTE: When connecting with a scan converter:
If an image from the scan converter is not correctly displayed, adjust to select the best level point so that the image is displayed correctly.
E – 34