Select "List" and press ENTER to display the direct Key assignment list.

Select "OK" and press ENTER to close the window.

To close the List window, press CANCEL on the remote.

Adjust (Source)

White Balance

Color Temperature

This feature adjusts the color temperature using the slide bar. Move the slide bar to the right to increase the color temperature for a bluish image; to the left to decrease it for a reddish image.

Brightness

Brightness for each color (RGB) is used to adjust the black level of the screen.

Contrast

Contrast for each color (RGB) to adjust the white level of the screen.

Signal Level

Picture

Brightness

Adjusts the brightness level or the back raster intensity.

Contrast

Adjusts the intensity of the image according to the incoming signal.

Saturation

Adjust saturation at the white peak.

Color

Increases or decreases the color saturation level (not available for RGB).

Hue

Varies the color level from +/- green to +/-blue. The red level is used as reference. This adjustment is only valid for Video and Component inputs (not available for RGB).

Sharpness

Controls the detail of the image for Video (not available for RGB and Component).

V-Aperture

Adjusts edge enhancement in the vertical direction. (not available for RGB)

Gamma Correction

This option corrects gamma. Select the appropriate item.

NTSC ..........................

Setting for NTSC signals

Graphics .....................

Setting for Computer Graphics

Graphics/NTSC ...........

Setting for both Computer Graphics and NTSC sig-

 

nals (Default value)

PAL/SECAM 2.8 ..........

Setting for PAL and SECAM signals at the gamma

 

value of 2.8

PAL/SECAM ................

Setting for PAL and SECAM signals

Natural 1 .....................

Setting for Video and S-Video signal

Natural 2 .....................

Setting for component signal (γ value 2.2)

R/G/B, Y/Cb/Cr or Y/Pb/Pr Gain:

Adjust RGB, Component or HDTV Gain to match multiple projector color uniformity.

Image

Pixel Adjust (when Auto Adjust is off)

Displays the Clock and Phase adjustments.

Clock ............ Use this item with the "Auto Adjust off" to fine tune the com-

puter image or to remove any vertical banding that might ap- pear.

Phase ........... Use this item to adjust the clock phase or to reduce video

noise, dot interference or cross talk. (This is evident when part of your image appears to be shimmering.) Use the ￿ and

￿buttons to adjust the image.

Use "Phase" only after the "Clock" is complete.

NOTE: When Auto Adjust is turned ON on the Page 4 of Setup, the Clock adjust is not available on this Pixel Adjust screen.

E – 32