Horizontal/Vertical Position (when Auto Adjust is off)
Adjusts the image location from left to right.
This adjustment is made automatically when the Auto Adjust is turned on.
Aspect Ratio (not available for RGB)
You can select the aspect ratio for input signal and display area re- spectively.
Select the appropriate aspect ratio using the SELECT , , ▲, or
▼button.
NOTE: When "Resolution" is set to "Native", this feature is not available, and the stored settings and adjustments are invalid.
Resolution (when Auto Adjust is off)
This allows you to activate or deactivate the Advanced AccuBlend feature.
Auto ............. | Turns on the Advanced AccuBlend feature. The projector au- |
| tomatically reduces or enlarges the current image to fit the |
| full screen. |
Native ........... | Turns off the Advanced AccuBlend feature. The projector dis- |
| plays the current image in its true resolution. See "Auto Ad- |
| just (RGB Only)" on page |
| Adjust feature. |
NOTE: While you are displaying an image with higher resolution than the projector's native resolution (SXGA:1280 x 1024), even when you are in the Native mode, the image is displayed full screen using the Advanced AccuBlend feature.
NOTE: The image with lower resolution than SXGA(1280 x 1024) is displayed in small when you are in the Native. In this case, you can use the lens shift, zoom and focus adjustments, which you saved in advance with "Cus- tom" of "Lens Memory", to enlarge the image to fit on the screen.
Overscan
Video Filter
This feature reduces video noise. Select the appropriate filter for your signal.
Bar 0 ............ | Off |
Bar 1/3 ......... | High |
Bar 2/3 ......... | Medium |
Bar full ......... | Low |
Blanking |
|
This feature allows you to mask any unwanted area of the screen image.
Blanking On/Off:
This setting enables or disables the blanking function.
On ................ | Blanking function is enabled. |
Off ................ | Blanking function is disabled. |
* Adjustment of vertical display range
Adjust the Top, Bottom, Left or Right blanking with the SELECT or
button.
Video AdjNoise Reduction
You can select overscan percentage for RGB signal.
Select the appropriate option using the SELECT or button.
NOTE: When "Resolution" is set to "Native", this feature is not available, and the stored settings and adjustments are invalid.
Select one of the following three levels for reducing video noise. Low, Medium or High.
NOTE: The lower the Noise Reduction level, the better the image quality. Increasing Noise Reduction lowers video bandwidth.
E – 33