Reference Manual for the ProSafe VPN Firewall FVS114

Power

Test

Internet

Local Port 4

Figure 3-4: Status lights

d.Check the VPN firewall router status lights to verify the following:

PWR: The power light should turn solid green. If it does not, see “Troubleshooting Tips” on page 3-6.

TEST: The test light blinks when the firewall is first turned on then goes off. If after two minutes it is still on, see “Troubleshooting Tips” on page 3-6.

INTERNET: The Internet LINK/ACT light should be lit. If not, make sure the Ethernet cable is securely attached to the VPN firewall router Internet port and the modem, and the modem is powered on.

LOCAL: A LOCAL light should be lit. Green on the 100 line indicates your computer is communicating at 100 Mbps; off on the 100 line indicates 10 Mbps. If a LOCAL light is not lit, check that the Ethernet cable from the computer to the firewall is securely attached at both ends, and that the computer is turned on.

Now, Configure the FVS114 for Internet Access

1.From the Ethernet connected PC you just set up, open a browser such as Internet Explorer or Netscape® Navigator.

3-4

Connecting the Firewall to the Internet

202-10098-01, April 2005

Page 28
Image 28
NETGEAR fvs114 manual Now, Configure the FVS114 for Internet Access, Status lights