Reference Manual for the ProSafe VPN Firewall FVS114

Step 1: Configuring the Client-to-Gateway VPN Tunnel on the FVS114

Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC default parameters listed in Table 5-1 on page 5-4. If you have special requirements not covered by these VPNC-recommended parameters, refer to Chapter 6, “Advanced Virtual Private Networking” to set up the VPN tunnel.

Follow this procedure to configure a client-to-gateway VPN tunnel using the VPN Wizard.

1.Log in to the FVS114 at its LAN address of http://192.168.0.1 with its default user name of admin and password of password. Click the VPN Wizard link in the main menu to display this screen. Click Next to proceed.

Figure 5-4: VPN Wizard start screen

2.Fill in the Connection Name and the pre-shared key, select the type of target end point, and click Next to proceed.

Note: The Connection Name is arbitrary and not relevant to how the configuration functions.

5-6

Basic Virtual Private Networking

202-10098-01, April 2005

Page 62
Image 62
NETGEAR fvs114 manual Configuring the Client-to-Gateway VPN Tunnel on the FVS114, VPN Wizard start screen