NETGEAR fvs114 manual Type ping -t 192.168.3.1 and then click OK

Reference Manual for the ProSafe VPN Firewall FVS114

a.Establish an Internet connection from the PC.

b.On the Windows taskbar, click the Start button, and then click Run.

c.Type ping -t 192.168.3.1 and then click OK.

Figure 5-34: Running a Ping test to the LAN from the PC

This will cause a continuous ping to be sent to the first FVS114. Within two minutes, the ping response should change from “timed out” to “reply.”

Note: Use Ctrl-Cto stop the pinging.

Figure 5-35: Ping test results

Once the connection is established, you can open the browser of the PC and enter the LAN IP address of the remote FVS114. After a short wait, you should see the login screen of the VPN Firewall (unless another PC already has the FVS114 management interface open).

•Gateway-to-GatewayConfiguration—test the VPN tunnel by pinging the remote network from a PC attached to the FVS114.

a.Open a command prompt (Start -> Run -> cmd).

b.Type ping 192.168.3.1.

5-28 Basic Virtual Private Networking

202-10098-01, April 2005