Using Other Functions
Editing Remote Control Display Names
Use this capability to rename the display on the remote control for different MULTI CONTROL buttons (DVD/LD, etc.). For example, you could change TV to DVD2. In this way you can personalize your system. This is similar to the feature on page 93 but that feature changes the display on the receiver.
1 Press the REMOTE SETUP for more than three seconds.
The REMOTE SETUP menu appears on the remote display.
2 Use the buttons to select
FUNCNAME and press ENTER.
SELECT FUNCTION will flash in the display.
3 Press the MULTI CONTROL button for the component you want to rename.
For example, TV
4 Use the buttons to select the letters and/or numbers you want to enter and use the buttons to move the cursor to the next position.
Here are the possible letters/numbers.
ABCDEFGHIJKLMNOPQRSTUVWXYZ abcdefghijklmnopqrstuvwxyz 0123456789
@[\]\^_`{}~ 
•(space)
You can input up to eight letter/numbers.
Memo:
•To exit from the REMOTE SETUP mode at anytime press the REMOTE SETUP button.
•The display will disappear after one minute or so if no new commands are entered. Press any button to wake up the remote and continue the process.
5When you're finished press ENTER, END will flash, press ENTER again.
The COMPLETE appears in the display.
6Go back to step 2 to input as many function names as you want.
7Select EXIT and press ENTER.
You will exit the REMOTE SETUP menu and return to normal operation.
EXPERT
83
En
