Techno Tidbits and
Symptom | Cause | Remedy |
Remote control
Cannot be remote controlled. • The remote control batteries have worn
out.
•Too far away or improper angle of opera- tion.
•There is an obstacle between the receiver and the remote control.
•Strong light such as fluorescent light is shining onto the unit's remote control signal
•A cord is connected to the CONTROL IN terminal on this unit.
•Replace the batteries (see page 7).
•Operate within 7 m and a 30° angle of the remote sensor on the front panel (see page 8).
•Remove the obstacle or operate from another position (see page 8).
•Avoid exposing the remote sensor on the front panel to direct light.
•Connect cord to the correct jack.
Other components can't be operated with the system remote.
•The preset code settings are wrong.
•The batteries wore out and the system settings were cleared.
•Input the correct preset code.
•Reset the proper system settings.
The SR cable is connected, but the connected components can't be operated with the remote.
•The SR cable hasn't been connected properly.
•The rest of the component connection have not been made.
•The component you have hooked up is not SR compatible.
•Reinsert the SR cable, making sure it is the right jack (see page 79).
•Make sure an analog connection has been made between the units.
•This is not a malfunction.
Miscellaneous
There seems to be a time lag between the speakers and the output of the subwoofer.
•The subwoofer channel can be delayed slightly if run through a
•The MCACC system will automatically compensate for a delay in the sub- woofer output during the Auto Sur- round Sound Setup.
If the unit does not operate normally due to external effects such as static electricity
Disconnect the power plug from the outlet and insert again to return to normal operating conditions.
Maintenance of External Surfaces
•Use a polishing cloth or dry cloth to wipe off dust and dirt.
•When the surfaces are dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and wrung out well, and then wipe again with a dry cloth. Do not use furniture wax or cleaners.
•Never use thinners, benzine, insecticide sprays or other chemicals on or near this unit, since these will corrode the surfaces.
EXPERT
115
En
