Remote Control of Other Components
Programming Signals from Other Remote Controls (LEARNING Mode)
If preset codes are not available for your component(s), or the available preset codes do not operate correctly, you can use this procedure to program in signals from the remote control(s) of your other component(s). These steps can also be used to add further operations to the remote control that were successfully set with the stored settings (see page 67).
Memo:
•To exit from the remote control setup mode at any time, press REMOTE SETUP.
•You can also program the /// and ENTER buttons with the LEARNING mode.
•The display will disappear after one minute or so if no new commands are entered. Press any button to wake up the remote and continue the process.
Buttons that are able to learn new commands
1Press the REMOTE SETUP button for three seconds.
The REMOTE SETUP menu appears on the remote dis- play.
2Use the buttons to select
LEARNING and press ENTER.
SELECT FUNCTION flashes on the remote control display.
3Press the MULTI CONTROL button for the component you want to control.
SELECT KEY flashes in the display.
The TUNER button cannot be assigned.
4Choose the command you want to teach the remote control and press the corresponding button. The word LEARN will flash in the remote control display.
For example, choose the (play) button to program this remote control to play your DVD player.
•The TV POWER, TV FUNC, TV CH +/– and VOL +/– but- tons are only available for learning when programming TV CONT button.
BASIC
69
En
