Pioneer VSX-AX5i-G manual Fine Tuning Your System

Fine Tuning Your System

Assigning the Digital Inputs

If you did not hook up your digital equipment in accordance with the default settings for the digital inputs (see pages 17, 19 and 22) you need to complete the procedure below. You have to do this in order to tell the receiver what digital equipment is hooked up to which terminal so the buttons on the remote correspond to what you have hooked up.

3-82

3

4

5

Memo:

•The possible digital inputs that can be assigned are: DVD/LD, TV/SAT, VCR1, VCR2, CD, CD-R, MD.

•If you assign a digital input to a certain function (for example DVD/LD) then any digital inputs previously assigned to that function will automatically be set to OFF. This is because one function cannot be assigned to two different places.

1Turn on the receiver and your TV, press RECEIVER on the remote con- trol.

2Press the SYSTEM SETUP button.

3Looking at the on-screen display on your TV, use the  buttons to select

INPUT ASSIGN. Press the ENTER button.

4DIGITAL–IN SELECT should be selected, if not use the  buttons to select it. Press the ENTER button.

5Use the  buttons to move through the different digital inputs and press the ENTER button.

6Use the  buttons select the component that you hooked up to that digital in. Press the ENTER button.

If you're not sure which component is connected to which digital in, look on the back of the receiver and check the cables you connected.

7When you're finished use the  buttons to select EXIT and press

ENTER.

This exits the DIGITAL–IN SELECT mode.

8Use the  buttons to select EXIT and press ENTER. Then, use the  buttons to select EXIT and press ENTER again.

This exits the SYSTEM SETUP mode and returns to normal operation.

EXPERT

89

En