NETGEAR fvs114 manual VPN Status/Log screen

Reference Manual for the ProSafe VPN Firewall FVS114

6.Repeat for the FVS114 on LAN B. Pay special attention and use the following network settings as appropriate.

•WAN IP of the remote VPN gateway (e.g., 14.15.16.17)

•LAN IP settings of the remote VPN gateway:

—IP Address (e.g, 192.168.0.1)

—Subnet Mask (e.g., 255.255.255.0)

—Preshared Key (e.g., 12345678)

7.Use the VPN Status screen to activate the VPN tunnel by performing the following steps:

Note: The VPN Status screen is only one of three ways to active a VPN tunnel. See “Activating a VPN Tunnel” on page 5-26for information on the other ways.

a.Open the FVS114 management interface and click on VPN Status under VPN to get the VPN Status/Log screen (Figure 5-30).

Figure 5-30: VPN Status/Log screen

b.Click on VPN Status (Figure 5-32) to get the Current VPN Tunnels (SAs) screen (Figure 5-31). Click on Connect for the VPN tunnel you want to activate.

Basic Virtual Private Networking 5-25

202-10098-01, April 2005