NetGear Print Server Manual
List of FTP Files and Commands Supported by the Print Server
Table FTP Files in the Directory lists the file names that appear in the directory.
FTP Files in the Directory
File Name | Purpose | Mode |
|
|
|
CONFIG | Configuration file | Read/Write |
|
|
|
PSINF | Device information | Read |
|
|
|
DEFAULTC | Reset device to default configuration | Read |
|
|
|
RESET | Reset device | Read |
|
|
|
PASSRESET | Clear password | Read |
|
|
|
SETIP | Save current IP address | Read |
|
|
|
Table FTP Commands lists the
FTP Commands
Command | Function |
|
|
dir | Lists files as shown in table FTP Files in the Directory. |
get FILENAME 
Retrieves a file. The only files that can be retrieved are CONFIG and PSINF.
get RESET
get
PASSRESET
get SETIP
put CONFIG
Resets the print server and terminates the current connection.
Clears the password.
Sets the current IP address as a static IP address.
To avoid an address conflict, do not use this command if a DHCP server assigned the IP address to the print server.
Copies the CONFIG file to the print server, overwriting the existing CONFIG file. After using this command to write a new configuration file, use the get RESET command; all LEDs should turn on and then off while the print server is resetting.
put
PASSWORD
Copies the password file to the print server and gives it a new password. Passwords can be up to 19 bytes in length.
put filename Ln 
Copies the filename file to the printer connected to n port and prints the file.
quit | Terminates the current FTP session. |
Other FTP commands cannot be used, and they return an Invalid Command error message.
56
