NETGEAR RT328 Network Checklist

Reference Guide for the Model RT328 and Model RH348 ISDN Routers
Router Installation and Connection 2-3
Network Checklist
The Model RT328/RH348 router uses the Internet Protocol (IP). The IP configuration has the
following requirements:
• Host devices must have established IP addresses (usually defined by your network manager or
Internet service provider).
• An IP address must be assigned to the router itself (usually defined by your network manager
or Internet service provider).
• Host devices must have the router defined either as the default gateway or as an entry in the
static routes table.
• The network or subnetwork numbers must be different on the Local and Remote netw orks you
are routing between.
If you do not have any assigned IP addresses, you must use NAT. In this case, assign IP addresses
from a group of designated private IP addresses. Refer to “Single IP Address Operation Using
NAT” on page 1-13 for more information about IP address masquerading. Refer to “IP Addresses
and the Internet” on page 1-7 for more information about TCP/IP network configuration.
Install.fm Page 3 Tuesday, October 10, 2000 3:16 PM