NETGEAR RT328 manual TCP/IP Tools, Trace Display for a Successful TCP/IP Protocol Connection

Sysmaint.fm Page 7 Tuesday, October 10, 2000 3:26 PM

Reference Guide for the Model RT328 and Model RH348 ISDN Routers

Figure 9-2 illustrates an example of a trace display for a successful call when using a TCP/IP protocol connection.

Start dialing for node <1>

### Hit any key to continue.###

Dialing chan<2> phone(last 9—digit):40101 Call CONNECT speed<64000> chan<2> prot<1> LCP up

CHAP send response

CHAP login to remote OK! IPCP negotiation started IPCP up

Figure 9-2. Trace Display for a Successful TCP/IP Protocol Connection

Figure 9-3 shows an example of a trace display for a failed call when using a TCP/IP protocol connection.

Start dialing for node<1>

### Hit any key to continue.###

Dialing chan<2> phone(last 9–digit):40101 Call CONNECT speed<64000> chan<2> prot<1> LCP up

CHAP send response

###Login to remote failed. Check name/passwd. Receive Terminate REQ

LCP down

Line Down chan<2>

Figure 9-3. Trace Display for a Failed TCP/IP Protocol Connection

TCP/IP Tools

Enter 11 to select the Internet Setup Test. This test checks to see if your Internet access configuration has been done correctly. The router dials the ISP, performs authentication, and establishes a connection. If everything is working properly, you receive an appropriate response. If you receive an error message, note the error message and consult your network administrator.

Enter 12 to select Ping Host. This diagnostic test pings a local or remote host. You are prompted for the IP address of the host.

System Maintenance 9-7