Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302
•The computer with the wireless adapter may not have the correct TCP/IP settings to communicate with the network. Restart the computer and check that TCP/IP is set up properly for that network. The usual setting for Windows the Network Properties is set to “Obtain an IP address automatically.”
•The access point’s default values may not work with your network. Check the access point default configuration against the configuration of other devices in your network.
I cannot connect to the WG302 to configure it.
Check these items:
•The WG302 is properly installed, LAN connections are OK, and it is powered on. Check that the LAN port LED is green to verify that the Ethernet connection is OK.
•The default configuration of the WG302 is for a static IP address of 192.168.0.228 and a Mask of 255.255.255.0 with DHCP disabled. Make sure your network configuration settings are correct.
•If you are using the NetBIOS name of the WG302 to connect, ensure that your computer and the WG302 are on the same network segment or that there is a WINS server on your network.
•If your computer is set to “Obtain an IP Address automatically” (DHCP client), restart it.
•If your computer uses a Fixed (Static) IP address, ensure that it is using an IP Address in the range of the WG302. The WG302 default IP Address is 192.168.0.228 and the default Subnet Mask is 255.255.255.0. If you are not sure about these settings, follow the instructions for “Use AutoCell Enhanced RF Security. In addition to standard encryption and security mechanisms such as WEP and WPA, the WG302 AutoCell feature provides
When I enter a URL or IP address I get a timeout error.
A number of things could be causing this. Try the following troubleshooting steps.
Troubleshooting |
September 2004