NETGEAR WNR834M manual Default Factory Settings, If WPA-PSK or WPA2-PSK Authentication is Used

NETGEAR RangeMax™ NEXT Wireless Router WNR834M Reference Manual

Key 3: ___________________________________

Key 4: ___________________________________

•If WPA-PSK or WPA2-PSK Authentication is Used:

–Passphrase: ______________________________ These characters are case sensitive. Enter a word or group of printable characters. When you use WPA-PSK, the other devices in the network will not connect unless they are set to WPA-PSK as well and are configured with the correct Passphrase. Similarly, when you use WPA2-PSK, the other devices in the network will not connect unless they are also set to WPA2-PSK and are configured with the correct Passphrase.

Use the procedures described in the following sections to configure the WNR834M. Store this information in a safe place.

Default Factory Settings

When you first receive your WNR834M, the default factory settings are in effect, as shown below. You can restore these defaults with the Factory Default Restore button on the rear panel. After you install the WNR834M router, use the procedures below to customize any of the settings to better meet your networking needs.

FEATURE	DEFAULT FACTORY SETTINGS
Wireless Router Radio	Enabled
Wireless Access List (MAC Filtering)	All wireless stations allowed
SSID broadcast	Enabled
SSID	NETGEAR
802.11b/g RF Channel	Auto
Mode	Up to 300 Mbps
Security	None

3-4 Wireless Configuration

v1.3, May 2006