NETGEAR RangeMax™ NEXT Wireless Router WNR834M Reference Manual
Configuring LAN TCP/IP Setup Parameters
The router is shipped preconfigured to use private IP addresses on the LAN side, and to act.as a DHCP server. The router’s default LAN IP configuration is:
•LAN IP
•Subnet
These addresses are part of the
The LAN IP parameters are:
•IP Address
This is the LAN IP address of the router.
•IP Subnet Mask
This is the LAN Subnet Mask of the router. Combined with the IP address, the IP Subnet Mask allows a device to know which other addresses are local to it, and which must be reached through a gateway or router.
•RIP Direction
RIP (Router Information Protocol) allows a router to exchange routing information with other routers. The RIP Direction selection controls how the router sends and receives RIP packets. Both is the default.
—When set to Both or Out Only, the router broadcasts its routing table periodically.
—When set to Both or In Only, the router incorporates the RIP information that it receives.
—When set to None, the router does not send any RIP packets and ignores any RIP packets received.
•RIP Version
This controls the format and the broadcasting method of the RIP packets that the router sends. (It recognizes both formats when receiving.) By default, this is set for
—
—
Note: If you change the LAN IP address of the router while connected through the 
browser, you will be disconnected. You must then open a new connection to the
new IP address and log in again.
Advanced Configuration of the Router |
