![](/images/new-backgrounds/1118988/118988129x1.webp)
WAN and System Configuration
IPX parameters (default profile) screen
If you are using RFC1483 datalink encapsulation, the IPX Parameters (Default Profile) screen allows you to configure various IPX parameters for SDSL connections established without an explicitly configured connection profile:
IPX Parameters (Default Profile)
NetBios Packet Forwarding: | Off |
Path Delay: | 10 |
Incoming Packet Filter Set... | <<NONE>> |
Outgoing Packet Filter Set... | <<NONE>> |
Incoming SAP Filter Set... | <<NONE>> |
Outgoing SAP Filter Set... | <<NONE>> |
Periodic RIP Timer: | 60 |
Periodic SAP Timer: | 60 |
For details on setting up IPX Parameters see “IPX Setup” on page
System configuration screens
You can connect to the Netopia R7200’s system configuration screens in either of two ways:
■By using Telnet with the Router’s Ethernet port IP address
■Through the console port, using a local terminal (see “Connecting a console cable to your router” on page
You can also retrieve the Netopia R7200’s configuration information and remotely set its parameters using the Simple Network Management Protocol (see “SNMP” on page
Open a Telnet connection to the router’s IP address; for example, “192.168.1.1.”