Radio Disassembly - Detailed

2-11

 

 

6.8Disassembly of Control Heads - CM300/PM400

1.Disconnect the flat cable from the Control Head PCB connector. See Figure 2-12.

2.Remove the PCB from the keypad assembly.

3.Remove the LCD assembly from the rubber keypad assembly.

4.Remove the keypad assembly from the control head housing by lifting it up from the face side.

5.Disconnect the speaker socket and remove the speaker from the keypad assembly.

NOTE DO NOT touch or contaminate the conductive pads on the under side of the keypad, the conductive contacts on the printed circuit board or the elastomeric connector.

Control Head Housing

Speaker

Keypad Assembly

 

 

LCD AssemblyPCB

Figure 2-12Control Head Housing Removal CM300/PM400

Page 25
Image 25
Nikon CM200 service manual Disassembly of Control Heads CM300/PM400, 12Control Head Housing Removal CM300/PM400