NOTE: If a code digit is 0, the LED does not blink
5.Continue through five digits by pressing 2 for the second digit, 3 for the third, 4 for the fourth and finally 5 for the fifth; counting the TV Source Key LED blinks for each digit.
6.To check for other device codes, repeat steps
configuring sources 2,3, and 4
These source device commands are learned directly from the original device remotes. There are some precautions to be observed:
Learning Precautions
Your original remote control device must be in working order to learn IR codes properly.
•Learned keys are device specific, so each key can store a unique function for each device
•Do not use the following keys for learning: Source Keys or SETUP.
•Learning capacity is approximately 42 to 75 keys, depending on the code being learned
•Certain device functions cannot be learned, including
•For optimum learning, avoid high levels of ambient light such as natural sunlight or
NOTE: Please have your original remote controls handy before programming learning
Programming a Learned Key
NOTE: If more than 10 seconds pass between key presses, the remote exits programming
1.Place the Niles
2.Locate the key (on your original remote control) that you want the
3.Press the device key for which you wish to learn IR commands.
4.Press and hold SETUP until the Source Key LED blinks twice, then release.
5. Enter 9 7 5. The Source Key LED blinks twice.
NOTE: If the LED displays one long flash instead, your batteries are low, or the
6.Press the key on the Niles
7.On the original device remote,
NOTE: If the source key LED displays one long blink, a learning error has occurred. Try repeating this step again until a successful capture is obtained.
If the function is still not captured, press and hold SETUP to exit programming and review the “Learning Precautions” above. If needed, also see “Troubleshooting”. After review, start programming again at step 1.
8.Repeat steps 6 through 7 for each key to be learned. Once all keys are learned,
Deleting a Single Learned Key
This process returns a single key to its original programming for the selected device only. Learned programming can also be deleted by teaching a different function to the key (see “Programming a Learned Key”).
NOTE: If more than 10 seconds pass between key presses, the remote exits programming.
1.Press the Source Key for the device for which a learned key is to be deleted.
2.
3.Enter 9 7 6. The Source Key LED blinks twice
4.Press the key containing the learned function to be deleted twice. The Source Key LED blinks twice and the
Deleting All Learned Keys FOR a Spe- cific device
NOTE: If more than 10 seconds pass between key presses, the remote exits programming.
1.
24 |
| NILES AUDIO CORPORATION – |