Niles Audio ZR-4 manual Choose A Mounting Location, Keypad Installation, INSTALL THE MASTER KEYs

KEYPAD INSTALLATION

The ZR-4 MultiZone Receiver Kit comes with four weather-resistant, wall-mount Keypads, one for each zone. A zone is an area or room of the house where music is desired, such as a living room, bedroom, kitchen, etc. Each zone is independent and can play any connected music source with its own volume and tone adjustments. Up to two keypads can be installed in each zone (requires ZR-KE Keypad Expander and an additional Solo-4 IR Keypad, both sold separately).

The SOLO-4 IR Keypad must be installed in an outlet box listed in accordance with the NEC.

CHOOSE A MOUNTING LOCATION

Convenient keypad mounting locations include:

1.	Near a doorway	Figure 16. Keypad Installation
2.	Near a desk	Solo-4IR

3.At your bedside

4.Close to a telephone

5. Near other wall-mounted controls

1 Gang

Low

Voltage

Box

KEYPAD INSTALLATION

1.Connect a properly configured CAT-5 cable to the “System” terminal on the back of the keypad. All CAT-5 cable requires RJ-45 connectors utilizing the T-568A wiring convention (See Figure 16).

2.Install keypad to low voltage electrical box as shown using included hardware.

3.Finish with appropriate color faceplate.

Decora style insert

Faceplate

WARNING: DO NOT MOUNT THE KEYPAD IN THE SAME ELECTRICAL BOX AS 110V AC DEVICES. THIS IS A VIOLATION OF THE ELECTRICAL CODE IN SOME AREAS.

INSTALL THE MASTER KEYs

Solo®-4 IR Keypads are shipped with the Master Keys uninstalled. 16 Master Keys are included (8 different labels for the left side,

8 different labels for the right side and a blank key for each side). To install the Master Keys:

1.Remove a Master Key from the “tree”. Note the difference between the left and right side versions

2.Insert the Master Key in the appropriate hole over the elastomer until you can feel it “click” when it is pushed in

Note: Master Key Labels can be installed while the keypad is installed on the wall. The Decora insert does not have to be removed.

CHANGING THE KEYPAD COLOR

The standard keypad color is White. Different colors are available to replace the Decora® insert and Master Keys: A complete list of available colors can be found at www.nilesaudio.com. To replace the Decora insert and Master Keys:

1.With a small screwdriver or knife, gently pry off the top of the Decora insert (two plastic tabs hold it in place). Remove the bottom of the Decora insert in the same manner. The Master Keys will come off with the Decora insert.

2.To reinstall, snap the new Decora insert in place, making certain that the buttons are seated over the elastomer.

3.Replace the Master Keys by inserting them in the appropriate holes over the elastomer until you can feel them “click” when pushed in.

	(continued on next page)
NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373		17