Troubleshooting continued
solution:
• Call Niles Tech Support
PROBLEM:
6. Poor or no radio reception solution:
•Check the receiver’s back panel to see if the FM dipole and AM loop antennas are connected. It may be necessary to reposition them to optimize reception.
PROBLEM:
7. Keypad does not function solution:
•Make sure that the
(See Figure 2)
•Check that the
PROBLEM:
8. No source control
solution:
•The infrared MicroFlasher® is not connected properly to the back of the receiver
•The infrared MicroFlasher® is not affixed properly to the controlled component
•The batteries in the
•The IR Sensor is turned off (see page 22)
PROBLEM:
9. A Zone does not turn on when in the Party Mode solution:
•Check the system configuration settings for Party or Whole House Mode (page 19)
PROBLEM:
10. A Zone does not turn on when in the Paging Mode solution:
•Check the system configuration settings for Paging (page 19)
HAND-HELD REMOTE CONTROL TROUBLESHOOTING
PROBLEM:
1. LED does not blink when you press a key. solution:
•Try pressing different keys. Replace the batteries with 2 new AA batteries
PROBLEM:
2. LED blinks when you press a key, but device does not respond. solution:
•Make sure the remote is aimed at your device and is not more than 40 feet away
PROBLEM:
3. LED blinks one long blink while in SETUP mode. solution:
•An entry error has occurred (for example, wrong key). Try entering the sequence again
PROBLEM:
4.Remote does not control devices or commands are not working properly.
solution:
•Try all listed codes for the device. Make sure the device operates with an infrared remote control
PROBLEM:
5. CH+,
•Due to RCA design from 1983 to 1987, only the original remote control will operate these functions
PROBLEM:
6.Channels do not change properly when directly entering digits to change channels.
solution:
•If the original remote control required you to press Enter to change channels, press Enter on this remote after entering the channel number
| (continued on next page) | |
NILES AUDIO CORPORATION – |
| 27 |