Operating the
Play Sources 2-4
1.Pressing any of these source keys will turn on the zone and allow you to listen to the source connected to that input at the preset start volume.
2.Additional control over the source’s functions is available using the
3.The 12V out on the rear panel of the
4.Pressing the Off key will turn off the zone. The 12V output on the rear panel becomes inactive if all other zones are off.
Troubleshooting
PROBLEM:
1. Front panel Display blinks: THERMAL WARNING.
If the
solution:
•Check that the speaker impedance in all zones is not below 4 ohms per channel. If four speakers are to be connected in a zone, they must be 8 ohm speakers connected in parallel.
•Check to make sure there is adequate space (see page 14) above the ventilation holes on the top of the
PROBLEM:
2. No sound (All Zones).
Front panel DISPLAY blinks: THERMAL PROTECTION.
If the
solution:
•Check that the speaker impedance in all zones is not below 4 ohms per channel. If four speakers are to be connected in a zone, they must be 8 ohm speakers connected in parallel.
•Check to make sure there is plenty of space above the ventilation holes on the top of the
Party Mode
1.
2.The 12V out on the rear panel of the
3.Pressing and holding the Off button for 3 seconds in any zone will turn off all zones. All 12V outputs become inactive.
PROBLEM:
3a. No sound from both channels (One or More Zones).
Front panel DISPLAY blinks: ZONE (X) LSPKR SHORT or ZONE (X)
RSPKR SHORT.
3b. Sound from only one channel (One or More Zones).
Front panel DISPLAY blinks: ZONE (X) LSPKR OK or ZONE (X) RSPKR SHORT.
If a speaker wire has a short circuit, the shorted channel(s) of the
solution:
•Turn the entire system off using the main power switch on the front of the
•Check for shorts and repair/ replace the speaker wire.
•Turn the system on using the main power switch.
PROBLEM:
4. No sound (One or More Zones).
Front panel DISPLAY blinks: AMPLIFIER FAILURE.
The output chip has acted to protect itself from potential damage. Other fault indicators include: blinking front panel zone LED(s) and blinking source and mute keys on the keypads.
solution:
• Call Niles Tech Support
PROBLEM:
5. No sound (All Zones).
Front panel DISPLAY blinks: POWER FAILURE.
The output chip has acted to protect itself from potential damage. Other fault indicators include: a blinking front panel zone LEDs and blinking source and mute keys on the keypads.
26 |
| NILES AUDIO CORPORATION – |