USER MANUAL
ENGLISH
7.Lower the main broom with the lever (92); it will start turning.
8.Turn on the vacuum system by pushing the switch (85) backward.
NOTE
The vacuum system turns on only when the main broom is lowered.
9.Lower the side brooms (10 and 11) with the lever (91).
NOTE
The side brooms (10 and 11) can be lowered and lifted even when the machine is moving.
The side brooms do not turn when they are lifted or when the main broom is lifted.
10. Start sweeping by turning the steering wheel (1) and moving the machine forward by pressing the pedal (2).
Stopping the machine
11.To stop the machine, release the pedal (2).
To stop the machine quickly, also press the service brake pedal (3).
In case of emergency, press the emergency
12.Lift the side brooms (10 and 11) with the lever (91).
13.Turn off the vacuum system by bringing back the switch (85) to the centre.
14.Lift the main broom (12) with the lever (92).
15.To stop the machine, turn the ignition key (82) to "0".
16.Engage the parking brake by pressing the pedal (3) and engaging the lever (4).
MACHINE OPERATION
WARNING!
Pay careful attention when operating the machine at high speed: sudden steering could cause this
Always reduce the speed before steering.
1.Avoid stopping for a long time with the machine in the same position and the brooms turning: this could create unwanted marks on the fl oor.
2.To collect light and bulky waste materials, lift the front skirt by pressing the pedal (5); take into consideration that the machine vacuum capability is reduced when the front skirt is lifted.
CAUTION!
When operating on wet grounds, it is essential to turn off the vacuum system with the lever (85) to prevent the dust filter from being damaged.
3.For machine proper operation, the dust fi lter must be as clean as possible. To clean it while sweeping, turn on the fi lter shaker by pressing the switch (85) forward for a few seconds.
During this operation the vacuum fan is automatically shut off.
After cleaning the fi lter, press the switch (85) backward to restart the vacuum system; then start sweeping again.
While working, repeat the procedure every 10 minutes on average (depending on the dustiness of the area to be cleaned).
NOTE
When the dust fi lter is clogged and/or the hopper is full, the machine cannot collect dust and debris anymore.
4.The hopper (17) should be dumped after each working period and whenever it is full (see the procedure in the next paragraph).
SR 1100S P
146 2559
15
