Nilfisk-ALTO SR1800C B-D Technical Data, Packing, General Checks, Machine Layout, Installation

Models: SR1800C B-D

1 110
Download 110 pages 56.69 Kb
Page 55
Image 55
PACKING

USER MANUAL GENERAL CHECKS

Before handling the machine, the route from where the vehicle is parked to where the machine is to be installed should be checked beforehand for any danger areas.

NOTE

Check that the floor is not too uneven, avoid driving the vehicle at high speeds, and avoid excessive swaying of the transported machine.

WARNING!

It is forbidden to get onto the machine, or stand or walk under it.

Lift the machine or the boxes as needed to handle the machine.

PACKING

Packing should be disposed according to the law in force.

INSTALLATION

When delivered, the machine is completely assembled and perfectly working, so it does not require any installation by the customer.

GENERAL CHECKS

Make sure the machine has been inspected before delivery (check the warranty).

Check that the machine has not suffered any damage during transportation and carry out the preliminary operations for setting the machine at work according to the instructions in the manual.

Check the hydraulic system oil level in the tank.

Check the brake fluid level.

Check the engine oil level.

Check radiator coolant level.

Refuel.

Start the machine.

Follow the maintenance instructions.

TECHNICAL DATA

USE

The sweeper has been designed to perform a complete cycle of industrial and urban cleaning: sweeping, waste collecting and dumping.

NOTE

Any use other than the one described can damage the machine or injure the operators.

The sweeping is carried out by one or more side brooms which convey the debris towards the centre of the machine and a cylindrical main broom sweeps the collected debris into the hopper. The dust is collected and controlled by a fan. The air released into the environment is filtered by a filter. The waste collected in the hopper may be dumped onto the ground or into special boxes at a maximum height of 1,510 mm.

MACHINE LAYOUT

SR 1800C D (See Fig. E)

1.Fan

2.Side broom

3.Hydraulic system oil tank

4.Steering wheel

5.Fuel tank

6.Drive hydraulic motor

7.Rear wheel

8.Frame

9.Engine

10.Drive hydraulic pump

11.Main broom hydraulic motor

12.Main broom

13.Accessory hydraulic pump

14.Dust suction filter

15.Hopper

16.Front wheels

17.Side broom hydraulic motor

18.Battery

19.Fan motor

33014817(2)2006-06 A

5

Page 55
Image 55
Nilfisk-ALTO SR1800C B-D Technical Data, Packing, General Checks, Machine Layout, SR 1800C D See Fig. E, Installation