Nilfisk-ALTO SR1800C B-D manuel dutilisation Drive direct current motor SR 1800C B

USER MANUAL

Drive direct current motor (SR 1800C B)

		Every 150	Every 200	Every 400	Every 6	Every	Every time
	Maintenance						a check is
		hours	hours	hours	months	year
							carried out
	Ensure that the surface along which the carbon
	brushes slide is covered with an even, shiny,
	transparent light grey film.
	Check that there are no black marks or burns
	between the commutator segments and on the
	commutator outer crown
	Ensure that the commutator surface is not lined,
	deeply grooved or burnt on the segment in or out
Commutator	edges.
	Check that the brooms have not grooved the
	commutator surface and that the insulating mica
	does not protrude from the copper segment.
	Check that the commutator is clean and that there
	are no burns on the segments; if necessary, clean
	the commutator as described.
	Check eccentricity.
	Clean the commutator with special rubber sticks. If
	necessary, clean between the segments.
	Check the carbon brush for wear. It is worn out
	when more than half of its total length has been
	consumed. Check that it slides freely in the brush
	holder, that it is pressed correctly by the spring and
	that the spring is still elastic.
	Ensure that the surface along which the carbon
	brushes slide is evenly and highly polished and
	that any lines or porosity are extremely small and
	of similar dimensions.
	Check the wire for wear and ensure that the
Carbon	connection terminals are well tightened.
brushes	Ensure that there are no big lines, deep grooves,
	craters, burns or splinters on the carbon brush
	edge and that all the carbon brushes are worn in
	the same way.
	Check the housing for wear and clearance.
	Brushes usually last from 6 months to 1 year,
	depending on use.
	Check the carbon brush and coupling pressure.
	When the warning light turns on, the carbon
	brushes need to be replaced, even if 300 hours
	have not been reached.
Terminals	Check that supply bolt nuts are well tightened and
	that the insulating materials are in good condition.
Fan	Ensure that air intakes are not clogged and that the
	fan turns freely.
Bearings	Check the temperature and the vibration and noise
	degree.
	Use a megger, especially when the environment is
Insulation	wet, to check the insulation value: it should never
	be less than 2 MOhm.
	Check that the screws are not loose.
Screws	Check that there are no faulty contacts in the
	electrical connections which could lead to local
	overheating.
Windings	General cleaning. Check that the insulation to
	ground is less than 2 MOhm.

33014817(2)2006-06 A 17