CC100Master Bridge User’s Guide
2
INSTALLATION
This chapter describes the installation procedure for your bridge.
Packing List
Your package should come with the equipment listed below,
♦One Main Unit (HCNA to Ethernet Master Bridge) CC100
♦One DC 5V Power Adaptor
♦One
♦One
Rear Panel
Figure 1: Rear Panel of CC100
Connectors
1.DC5V: Connect to the power adapter plug.
2.LAN1/LAN2: Two fast Ethernet ports to connect Switch/FTTx/xDSL Modem for Internet access.
3.Reset: While CC100 is turned on, press and release this button to reboot CC100. Pressing it for 5 seconds will restore all settings back to factory default. For example, the IP address will restore to default ‘192.168.1.1’.
4.HCNA: Attach to existing coaxial cable and use it as the networking backbone in one or more MDUs. CC100 is the HCNA Master device and controls the other Slave HCNA devices (refer to Endpoint or EP, as CC101) on the same coax network. Refer “Connecting the Cables” for more details.
5.TV/Antenna: Connect to TV Set. Or connect to VHF/UHF antenna or CATV to bypass TV signal to HCNA port.
LED Indicators
1.Power: Lights up when power on.
2.LAN1: Lights up when LAN1 port is active and flashing when there is any data traffic.
3.LAN2: Lights up when LAN2 port is active and flashing when there is any data traffic.
4.Link/Act: Lights up when HCNA port is active and flashing when there is any data traffic.
5.SyncMode: Lights up when HCNA port is working in HCNA Synchronous MAC mode.
6.Diagnosis: Lights up when CC100 is diagnosing EP.
NOTE: HCNA always adopts the Synchronous MAC protocol layer in coax system in order to coordinate all the transmissions and eliminate any collisions. The SyncMode LED should always be on as long as power is on.
2
