31
Most INCLINE TRAINER problems can be solved by following the steps outlined in this section. Find any
symptoms that apply, and follow the steps listed. If further assistance is needed, please contact your dis-
tributor.
1. SYMPTOM: THE POWER DOES NOT TURN ON
a. Make sure that the power cord is plugged into a properly grounded outlet. (Refer to page 10.)
b. Make sure that the key is inserted into the console.
c. Check the on/off circuit breaker located on the INCLINE TRAINER near the
power cord. Make sure that the on/off circuit breaker is switched to the on
position.
2. SYMPTOM: THE POWER TURNS OFF DURING USE
a. Check the on/off circuit breaker located on the INCLINE TRAINER near the power cord. (See drawing 1. c.
above.) Make sure that the on/off circuit breaker is switched to the on position.
b. Make sure that the power cord is plugged in.
c. Remove the key from the console. Reinsert the key into the console.
d. If the power still turns off during use, please contact your distributor.
3. SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON
a. If the walking belt is overtightened, performance may
decrease and the walking belt may be damaged. If
the walking belt is properly tightened, you should be
able to lift each side of the walking belt 1 to 2 inches
off the walking platform. If adjustments need to be
made, first remove the key and unplug the power
cord.Using the included allen wrench, turn both roller
adjustment bolts counterclockwise 1/4 of a turn. Be
careful to keep the walking belt centered. Plug in the
power cord, insert the key, and use the INCLINE
TRAINER for a few minutes. Repeat until the walking
belt is properly tightened. Note: To tighten the walking
belt, see step 7. c. on page 32.
b. Make sure that the walking platform is properly lubricated. (See step 4 of MONTHLY MAINTENANCE on
page 27.)
c. If the walking belt still slows when walked on, please contact your distributor.
“On”
Position
c

60”

a1”–2”
TROUBLESHOOTING
Roller Adjustment Bolts