18. Route the Low Cable (72) through the indicated slot | 18 |
|
|
in the Main Upright (3) and the Base (8). |
|
| |
| 35 |
| |
|
|
| |
Wrap the Low Cable (72) around a 4Ó Pulley (35) in |
| 62 |
|
the direction shown. |
|
|
|
Attach the 4Ó Pulley (35) to the welded bracket on the |
|
|
|
Main Upright (3) with a 3/8Ó x 2Ó Bolt (62) and a 3/8Ó |
| 72 |
|
Nylon Locknut (50). |
| Slot | |
|
| ||
| 50 | 3 | 8 |
|
|
| |
19. Wrap the Low Cable (72) around a 4Ó Pulley (35). | 19 |
|
|
|
|
|
Slide the 4Ó Pulley (35) and a Cable Trap (44) in between the two Pulley Plates (31).
Attach the 4Ó Pulley (35) and the Cable Trap (44) to |
| |
the lowest adjustment hole in the Pulley Plates (31) |
| |
with a 3/8Ó x 1 3/4Ó Bolt (60) and a 3/8Ó Nylon Jamnut | 31 | |
(63). Make sure the Cable is in the groove of the | ||
Adjustment | ||
Pulley and that the Cable Trap is oriented as | ||
shown, so it will hold the Cable in place. | Holes | |
| 60 | |
| 63 | |
| 44 | |
| 72 | |
| 35 |
20. Slide a Cable Trap (44) onto a 3/8Ó x 4Ó Bolt (65). | 20 | 72 | 44 |
| |||
|
| ||
Wrap the Low Cable (72) around a 4Ó Pulley (35). |
|
| 65 |
Attach the Pulley to the indicated hole in the Main |
|
| |
| 42 |
| |
Upright (3) with the 3/8Ó x 4Ó Bolt (65), the Cable Trap |
|
| |
|
|
| |
(44), a 5/8Ó x 1/2Ó Pulley Bushing (42), a 3/8Ó Flat |
|
|
|
Washer (55), and a 3/8Ó Nylon Jamnut (63). Make |
|
|
|
sure the Cable Trap is oriented as shown, so it |
|
| 3 |
will hold the Cable in place. |
|
| |
|
|
| |
|
| 55 | 35 |
|
| 63 | |
|
|
|
12
