27.Note: Some of the parts used in the following miscellaneous assembly are located in the parts bag labeled ÒSeat Assembly.Ó

Slide the four Tinnerman Clips (38) down over the slots in the bracket on the Stabilizer (5).

28.Attach the upper end of the Shroud (56) to the two ÒLÓ-brackets on the Top Frame (1) with two 1/4Ó x 3/4Ó Bolts (17), two 1/4Ó Flat Washers (71) and two 1/4Ó Nylon Locknuts (25).

Note: Line up the indicated corner of the Shroud

(56)with the indicated corner of the Top Frame

(1).The Bolts (17) go through the square holes in the Shroud. Do not tighten the Bolts yet.

29.Attach the lower end of the Shroud (56) to the brack- et on the Stabilizer (5) with four #8 x 3/4Ó Screws (32). The Screws go through the square holes in the Shroud and into the Tinnerman Clips (38).

Note: For the sake of clarity, this step shows the Shroud as if step 27 had not yet been performed.

27

 

 

38

5

 

 

38

28

1

 

17

 

ÒLÓ-Bracket

Line Up

 

71

Corners

 

 

25

 

71

17

56

 

29

 

 

5

 

 

 

38

 

 

38

32

 

 

 

Bracket

 

 

32

32

 

56

30.Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in ADJUSTMENT, beginning on page 17 of this manual.

Before using the training system, pull each cable a few times to be sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. If there is any slack in the cables, you will need to remove the slack by tightening the cables. See TROUBLE- SHOOTING AND MAINTENANCE on page 19.

15

Page 15
Image 15
NordicTrack NTSY06990 manual