Trouble-shooting and Maintenance
Inspect and tighten all parts each time you use the training system. Replace any worn parts immediately. The training system can be cleaned using a damp cloth and mild
Tightening the Cables
Woven cable, the type of cable used on the training sys- tem, can stretch slightly when it is first used. If there is slack in the Cables before resistance is felt, the Cables should be tightened.
To tighten the Cables, insert the Weight Pin (39, not shown) between the third and the fourth Weight, counting from the top. See ÒChanging the Weight SettingÓ on page 17 for instructions on moving the Weight Pin.
Loosen the 1/2Ó Plain Nut (68) securing the bolt at the end of the High Cable (73). Tighten the bolt a couple of turns into the Weight Tube (36) until the Cables feel tighter. Tighten the Plain Nut to prevent the bolt from turn- ing.
Note: This drawing shows the Shroud removed for clarity. The Shroud does not have to be removed to tighten the Cables.
Additional slack can be removed by moving the lower of the two 4Ó Pulleys (35) attached to the Pulley Plates (31) to one of the other adjustment holes in the Pulley Plates. To do this, remove the 3/8Ó x 1 3/4Ó Bolt (60), Cable Trap
(44)and 3/8Ó Nylon Jamnut (63). Move the Pulley and re- attach it with the Bolt, Cable Trap and Locknut. Make sure the Low Cable (72) is in the groove of the Pulley and that the Cable Trap is positioned as shown.
Note: If a Cable tends to slip off the Pulleys often, the Cable may have become twisted. Remove the Cable and
If the Cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.
73 |
Bolt |
68 |
36 |
39 |
31 |
|
| 60 |
63 | 44 |
| |
35 |
|
72 |
|
19
