Frame Assembly
1.
Before beginning assembly, make sure you have read and understood the information on page 5. This brief introduction will save you much more time than it takes to read it!
Open the parts bag labeled ÒFRAME ASSEMBLY.Ó
Press a 2Ó Square Inner Cap (33) into the support tube on the Main Upright (3).
Press a 2Ó x 3Ó Inner Cap (24) into the open end of the Main Upright (3) and into each end of the Stabilizer (5).
Attach the Stabilizer (5) to the Main Upright (3) with two 3/8Ó x 3 3/4Ó Carriage Bolts (52) and two 3/8Ó Nylon Locknuts (50). Do not tighten the Nylon
Locknuts yet.
2.Press a 2Ó Square Inner Cap (33) into the upper end of the front leg on the Base (8) and into the upper end of the Leg Lever (29).
Line up the bracket on the Base (8) with the holes in the Main Upright (3). Insert a 3/8Ó x 4Ó Bolt (65) through the bracket and the Main Upright from the front. Secure the Bolt with a 3/8Ó Flat Washer (55) and a 3/8Ó Nylon Locknut (50).
Do not tighten the Nylon Locknut yet.
Insert two 5/16Ó x 3Ó Bolts (78) through the bracket and the Main Upright (3) from the side.
Do not tighten the Nylon Locknuts yet.
3.Attach the Leg Lever Lock (11) to the front leg with a 5/16Ó x 3Ó Bolt (78), three 5/16Ó Flat Washers (80) and a 5/16Ó Nylon Jamnut (79). Do not overtighten the
Nylon Jamnut; it must be easy to turn the Leg Lever Lock.
Attach the Leg Lever Bumper (6) to the front leg with a #10 x 1Ó Tap Screw (7).
1
24
Support Tube 
|
|
| 33 |
|
| 3 |
|
| 50 | 50 |
|
|
|
| |
|
|
| 24 |
| 5 |
|
|
24 |
| 52 |
|
2 |
|
| 33 |
|
|
| |
| 3 | 78 |
|
|
|
| |
|
| 65 | 29 |
50 | 55 |
|
|
| 21 | 8 |
|
|
|
| |
|
| Front Leg |
|
3 |
|
|
|
| Front Leg | 80 | 78 |
|
| ||
|
|
| |
|
|
| 11 |
|
|
| 6 |
|
|
| 7 |
| 80 |
|
|
| 79 |
|
|
6
