4.Attach the Foot Plate (4) to the Base (8) with a 3/8Ó x 5 1/2Ó Bolt (57) and a 3/8Ó Nylon Locknut (50).
5.Place two Weight Bumpers (19) over the indicated holes in the Stabilizer (5).
Insert the two Weight Guides (23) through the Weight Bumpers (19) and the holes in the Stabilizer (5).
Attach the indicated Weight Guide (23) to the Stabilizer (5) with a 3/8Ó x 2 1/2Ó Bolt (54), two 3/8Ó Flat Washers (55), two 5/8Ó x 1/2Ó Pulley Bushings (42), and a 3/8Ó Nylon Jamnut (63).
6.IMPORTANT NOTE: If you purchased the optional weight expansion set, please refer to the userÕs manual accompanying the set to assemble the weights. After you have assembled the weights, refer back to this manual and continue with ÒArm AssemblyÓ found on the next page.
See the inset drawing. Press two Weight Inserts (77) into the indicated holes in each Weight (26). Make sure the large pin groove is oriented as shown.
Slide all of the included Weights (26) onto the two Weight Guides (23). Make sure the Weights are ori- ented correctly. The holes must be turned towards the front of the unit, as shown.
Slide the Top Weight (16) with the
Place the Top Frame (1) over the Weight Guides (23), so the Weight Guides fit into the welded tubes on the Top Frame.
Align the bracket on the Top Frame (1) with the holes in the Main Upright (3). Insert two 3/8Ó x 3Ó Bolts (45) through the holes. Tighten a 3/8Ó Nylon Locknut (50) onto the lower of the two Bolts. Do not mount a
Locknut on the upper Bolt yet.
Attach the Weight Guides (23) to the Top Frame (1) with two 3/8Ó x 1 3/4Ó Bolts (60), and two 3/8Ó Nylon Locknuts (50). Go back and fully tighten all of the
Nylon Locknuts used in steps 1, 2 and 6.
4 |
|
|
|
|
|
| 57 |
| 8 |
|
|
| 50 |
| 4 |
|
|
| |
5 |
|
| 5 |
|
| 23 | |
|
|
| |
63 |
| 19 | |
19 |
| ||
|
|
| |
55 |
|
|
|
| 42 |
| 55 |
|
|
| 54 |
|
|
| 42 |
6 | 50 | 1 | 45 |
|
| 50 |
|
Welded |
| 60 | |
|
| ||
Tubes |
|
| |
23 |
| 3 | |
|
| ||
16 |
|
|
|
| 36 |
| 77 |
|
|
| |
|
|
| 26 |
26 |
|
|
|
Holes |
| Large Pin | |
| Groove | ||
|
|
| |
7
