Installing and Connecting the Hardware
Using Only AC Power Source
"Procedure
To supply power to the 8600 chassis using a single ac power source:
1.Plug the ac power cord into the AC INPUT connector on the Interface Panel.
- | 48V | ||
| B | ||
A | |||
|
RTN | |
A | B |
|
INPUT 48VDC
A B |
F
RTN G
B
A
INPUT
48VDC
2. Plug the other end of the ac power cord into your ac power receptacle.
NOTE:
The ac power source should be a
3. Make sure the PWR A LED on the front panel is ON (green).
Using AC Power with DC Power Backup
"Procedure
To supply both ac and dc power to the 8600 chassis for power redundancy:
Make sure that the dc power source wires are not powered (i.e., the circuit breakers are open).
The ends of the dc power source wires (14 AWG ± 18 AWG solid or stranded wire) must be stripped of insulation. If they are not stripped of insulation, strip the tip of each wire (about
| October 1997 |