Nortel Networks 8600 manual Connecting to an SNMP Management System, 2-25, Procedure, To SNMP

Installing and Connecting the Hardware

Connecting to an SNMP Management System

"Procedure

To connect the HotWire 8600 DSLAM base chassis (i.e., the chassis that contains the MCC card) to an SNMP management system:

1.Plug the end of an 8-pin modular cable into the MANAGEMENT MCC port of the HotWire 8600 DSLAM base chassis.

2.Dress the 8-pin cable under the 8600 chassis to the left and behind the left support foot.

3.Plug the other end of the cable into the 10BaseT hub connector to the SNMP management system network.

Refer to Appendix B, Pinouts, for pin assignments.

	AC
	T5A
	250V
48V	RTN
A B	A B
AC
INPUT
48VDC CLASS 2 OR
LIMITED PWR SOURCE

SYSTEM

OK

Alrm

Test

ETHERNET

TX

RX

Col

DSL

PORT 1

2

3

4

SYSTEM

OK

Alrm

Test

ETHERNET

TX

RX

Col

DC FUSES		FAN	DC PWR		MANAGEMENT				LAN/WAN SLOT	LINE
t4a, MIN. 48V
	3 4	5 6 .
A	21	. .. ALM	A	B
	B	STACK		IN	OUT	SERIAL	MCC	1	2	3
	POSITION

RADSL	8546
MCC	8000

3

2

1

DC PWR		MANAGEMENT				LAN/WAN SLOT
A	B
	IN	OUT	SERIAL	MCC	1	2	3

To SNMP	97-15376-02
Management System

8600-A2-GN20-20 October 1997 2-25