Nortel Networks 8600 manual 2-17, AC T5A 250V, Ac Input, 48VDC CLASS 2 OR LIMITED PWR SOUR

Installing and Connecting the Hardware

1.Plug the ac power cord into the AC INPUT connector on the Interface Panel.

2.Insert the following wires in the appropriate terminal and securely fasten each wire by tightening the screw above it. The insulation should be fully within the terminal block and no bare wire should be exposed outside of the block.

NOTE:

You should clearly label these power source wires as ±48V and RTN respectively.

Insert Power Source B's . . .

Into the . . .

Wire

±48V B input terminal.

RTN wire

RTN B (return) terminal.

3.Dress the wires under the 8600 chassis to the left and behind the front left support foot.

AC

T5A

250V

AC

INPUT

–48V		RTN
A	B	A B

48VDC CLASS 2 OR LIMITED PWR SOUR

-48V A B

RTN A B

F G

48VD

97-15447-01

4.Plug the other end of the ac power cord into your ac power receptacle.

5.Power the HotWire 8600 DSLAM chassis by closing the circuit breakers or reinstalling the fuses.

6.Make sure the PWR A and DC PWR B LEDs on the front panel are both ON (green).

8600-A2-GN20-20 October 1997 2-17