14
Programming
Alarm
Reporting
The alarm programming session allows you to program the FastRAD to report alarms to the telephone number of a dedicated alarm center, such as a printer or terminal.
Before you begin an alarm programming session, make sure the display shows RAD Admin.
If you do not have this display on the Norstar telephone, follow the steps listed in Starting a Programming Session.
To program the FastRAD Alarm Reports:
1.Press ALARM.
The display shows: | ||
| BACK | CHNG NEXT |
2.Press CHNG to turn automatic alarm reporting on.
The display shows: | ||
| BACK | CHNG NEXT |
3.Press NEXT.
The display shows: | Report line: 001 | |
| BACK | CHNG NEXT |
4.Press CHNG.
The display shows: | Report line:_ | |
| CLEAR | BKSP OK |
5.Enter the KSU line number the FastRAD uses for remote connections. Refer to the Programming Record for the correct line number.
6.Press NEXT.
The display shows: | Alarm number 1 | |
| BACK | SHOW NEXT |
7.Press SHOW to see where the FASTRAD reports its alarms.
The display shows: | <Alarm number> | |
| BACK | CHNG NEXT |
